User Manual

10
STAINLESS STEEL
The stainless steel must be cleaned regularly (e.g.weekly) to ensure long life
expectancy.
Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may be used.
Ensure that wiping is done along with the grain of the stainless steel to prevent any
unsightly crisscross scratching patterns from appearing.
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is
clean and well wrung before cleaning. Use a dry soft cloth to remove any excess
moisture left after cleaning.
Using neutral detergents and avoid using harsh cleaning chemicals, strong household
detergents or products containing abrasives, as this will affect the appliance
appearance and potentially remove any printing of artwork on the control panel and
will void manufactures warrantee.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water with
a mild detergent then brush it gently with a soft brush. Please do not apply too much
pressure, avoid to damage it . (Leave to dry naturally out of direct sun light) Filters
should be washed separately to crockery and kitchen utensils. it is advisable not to
use rinse aid.
INSTALLING GREASE MESH FILTERS
To install filters for the following four steps.
1. Angle the filter into slots at the back of the
hood.
2. Push the button on handle of the filter.
3. Release the handle once the filter fits into a
resting position. 4. Repeat to install all filters.
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed at three or six months according to your cooking habit. The
installation procedure of activated carbon filter is as below.
1. Put the pin of the carbon filter into the
rectangular hole of the fan(as per the arrow A
shown below)
2. Push the other side of the carbon filter toward
the fan to make it flat(as per the arrow B
shown),and then press filter into fan.
3. If you want to remove the filter, press fastener of filter and remove it by turning
anticlockwise.