User Manual
9 
MULTI PROTECTIVE FUNCTIONS 
FROST PROTECTION 
In  COOL,  DRY  or  SMART  COOL  modes,  if  the  temperature  of  the  exhaust  is  too  low,  the  machine  will 
automatically stop operating until the temperature has risen. 
OVERFLOW PROTECTION 
When the water in the internal water tank exceeds the warning level, the machine will stop operating and sound 
an alarm with the LCD display showing “E7”. To resume operation empty the internal water tank. After the 
water is emptied, the machine will automatically return to the original state. 
AUTO-DEFROST 
The machine has automatic defrosting function. If during operation the temperature of the internal coils drops 
too low, the unit will enter auto defrost and the heating symbol will flash on the control panel. 
AUTOMATIC THERMAL PROTECTION 
To protect the service life of the machine, the machine has automatic thermal protection. If the temperature 
within the unit is outside of the specified range, the compressor and the lower motor will stop operation. The 
appliance will automatically return to normal operation after the temperature of the machine recovers. 
COMPRESSOR PROTECTION 
To prevent damage to the compressor there is a 3 minute delay start protection function. 
EMPTYING THE INTERNAL WATER TANK 
MANUAL DRAINAGE: 
When the internal water tank is full the unit will stop working. 
Shut off the unit and unplug. Try not to move the model abruptly as this may 
cause the water in the internal tank to spill out. 
Place a tray under the lower water plug or place the unit in a drainage area. 
Unscrew the drain plug cap and remove the rubber stopper - water will drain 
from the internal tank. Put the rubber stopper back and screw the drain plug 
cap back into place. 
CONTINUOUS DRAINAGE: 
Unscrew the drain plug cap and remove the rubber stopper. 
Connect a water pipe to the upper water outlet. 
You can plumb this pipe into your current plumbing system, lead it outside and 
use gravity fall or use a water pump. 
NOTE: This model has a self-evaporative function, which reduces the need to empty the water tank. If the unit 
is vented correctly most of the water is reused to cool the condenser coils and any excess is evaporated. Please 
do not use continuous drainage if you intend to use the self-evaporating facility. 










