USER MANUAL E-SC1-V2 ELECTRIC SCOOTER Thank you for choosing electriQ Please read the manual before using this scooter and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY WARNINGS 3 SCOOTER DIAGRAM 4 ASSEMBLY 5 FIRST USE 5 UNFOLDING THE SCOOTER 6 FOLDING THE SCOOTER 6 TURNING ON AND OFF 7 HOW TO RIDE 7 TIGHTENING THE HANDLEBAR STEM 7 DISPLAY 8 MAINTENANCE 9 BATTERY REMOVAL 9 STORAGE 10 TECHNICAL SPECIFICATIONS 10 SUPPORT 10 2
SAFETY WARNINGS • • • • • • • • • • • • • • • • • • • • • • Carefully read the user manual before use to avoid the risk of injury. Keep the user manual safe for future reference. This scooter is not a toy. The scooter can only be used by people aged 14 years old and over.
NOTE: Pictures and information in this manual may vary from the product, due to continuous product improvement. BATTERY SAFETY • The scooter comes supplied with a lithium battery. Care must be taken with the battery and charging to maintain its lifespan. • Do not expose the scooter or battery to naked flames or extreme heat. • Do not expose the scooter or battery to extreme cold. • Do not allow moisture to enter the battery compartment or charging port. • Only use the provided charger.
ASSEMBLY To assemble the handlebar, it must first be fitted into the top of the handlebar stem. Slide the silver base of the handlebars into the stem and align the 4 holes (2 on either side). Then insert the 4 bolts provided loosely into the holes. Once all 4 are in position tighten them to fix the handlebar into place, taking care not to damage any of the interior wiring. FIRST USE IMPORTANT: Before using the scooter for the first time, fully charge the battery.
UNFOLDING THE SCOOTER From the folded position, unclip the handlebar from the hook on the rear mudguard. When the handlebar is in the vertical position, lock it into place using the clamp on the front of the handlebars. Ensure that the clamp is fully secure before using. FOLDING THE SCOOTER Unfasten the handlebar clamp and fold the handlebars from the clamp towards the back wheel. Fix the handlebar to the hook on the mudguard, ensuring it is securely locked in position.
TURNING ON/OFF IMPORTANT: Make sure the scooter is upright and placed on a flat surface before starting. Press and hold the power button below the handlebar, for around 2 seconds to turn on the scooter. Press and hold the power button again to turn off the scooter. HOW TO RIDE 1. 2. 3. 4. Place one foot firmly on the deck, keeping your other foot on the ground for balance. Press the accelerator on the right handle and put your other foot on the scooter when it begins to move.
DISPLAY • The LED display on the handlebar will turn on after powering up the scooter. • The scooters battery level is displayed at the bottom of the display. During use, the number of bars on the battery level indicator will decrease. • When the battery level reduces, the bars will disappear until the battery is empty. The battery warning indicator will illuminate when the battery is at critical level.
MAINTENANCE The scooter requires routine cleaning and maintenance. • • • • • Before any work is carried out on the scooter, ensure that the charging cable is not connected and that the scooter is powered off. To clean the scooter, wipe the exterior with a soft damp cloth, then dry immediately. The exterior of the scooter is dustproof and splash proof with a water ingress rating of IPX4. Do not allow water to get inside of the scooter.
STORAGE • • • To protect the battery, ensure it is charged until the display shows 3 bars before storage. If you plan on storing the scooter for a prolonged period, the scooter should be charged to 3 bars every 2 months to avoid deterioration of the battery. Do not store the scooter at less than 7⁰C or above 25⁰C Keep the scooter inside its own packaging, or cover it to prevent dust build up. Keep the scooter indoors at all times when not in use.
