User Manual

12
SETTING UP THE WIFI APP
BEFORE YOU START
Ensure your router provides a standard 2.4GHz connection.
If your router is dual-band ensure that both networks have different network names (SSID). The provider
of your router / Internet service provider will be able to provide advice specific to your router.
Place the dehumidifier as close as possible to the router during setup.
Once the app has been installed on your phone, turn off the data connection, and ensure your phone is
connected to your router via WiFi.
DOWNLOAD THE APP TO YOUR PHONE
Download the ”TUYA SMART” app, from your chosen app store, using the QR codes below, or by
searching for the app in your chosen store.
Android IOS
CONNECTION METHODS AVAILABLE FOR SETUP
The smart device has two different setup modes, CF (Quick Connection) and AP (Access Point). The quick
connection is a quick and simple way to set the unit up. AP connection uses a direct local wifi connection
between your phone and the dehumidifier to upload the network details.
Before starting the setup, please ensure that your dehumidifier is in the correct standby mode for the
connection type you are attempting, the display your dehumidifier will indicate this.
To connect to the WIFI, press and hold the FUNCTION button when the unit is in standby mode for
approximately 7 seconds
CHANGING BETWEEN CONNECTION MODES / WIFI RESET
To change the unit between the two connection types, hold the FUNCTION button for 7 seconds. The
connection mode is signified by the frequency of the flashing Smart light. This will also remove any
previous WIFI configuration.
Connection Type
Frequency of Flashes
CF (Quick Connection)
Flashes twice per second
AP (Access Point)
Flashes once per second