User Manual

11
SET UP CONTINUOUS DRAINAGE
The dehumidifier has a continuous drain hole that can be connected to a plastic pipe with a 14 mm inner
diameter (not supplied). Water can be drained into a large receptacle or sink, for example, or through the
wall into an outside drain. Please follow the steps below to set your unit up for continuous drainage.
1. Cut off the cover for the continuous drain on the back of the unit.
2. Remove the water tank and connect a water tube with an inner
diameter of 14mm to the drain connector, and ensure the connection
is tight
3. Replace the water tank into position within the unit.
This unit uses gravity to dispose of the water collected and as such the drain should be lower than the
dehumidifier water outlet. Be sure to run the water pipe downwards and let the water flow out smoothly. Do
not kink or bend the pipe.
NOTES:
When the continuous drain feature is not being used, remove the pipe installation, to start the water
collecting in the water tank.
The permanent drain can be used in conjunction with a water pump (e.g. when draining from a cellar)
to lift the water upwards.
Plastic block