User Manual

23
CONNECTION TROUBLESHOOTING
1. Check whether the device is powered on and is in the correct standby mode, if not please refer to the
CHANGING BETWEEN CONNECTION MODES section on page 12.
2. Ensure the wifi password has been entered into the app correctly (Case sensitive)
3. Check that the phone is connected to the wifi you are connecting the device to.
4. Ensure the network you are connecting it to is 2.4Ghz (5Ghz wifi networks are not supported), and that
there is a strong wifi signal to the item.
5. If your router is dual band, ensure that the 2.4ghz network has a different network name (SSID). Further
advice on changing router settings will be available from your Internet service provider / Router
manufacturer.
6. Check the settings on the router. Encryption should be WPA2-PSK and authorisation type should be set
to AES
7. Try using the alternative connection method. i.e. If connection is failing when attempting to connect
through CF mode, try AP mode.
CARE AND MAINTENANCE
Always shut off the unit and unplug from the mains before cleaning or performing any maintenance. When it is
not in use for long periods it is advisable to remove the plug from the power socket. Do not use chemical solvents
(such as benzene, alcohol or gasoline) as they may cause irreversible damage to the unit.
1. CLEAN THE GRILLE AND CASE
Use water and a mild detergent to clean
the washable mesh filters. Do not use
bleach or abrasives. Do not splash water
directly onto the main unit. Doing so may
cause an electrical shock and can lead
to the insulation to deteriorate, or cause
the unit to rust. The air intake and outlet
grilles get soiled easily, so use a vacuum
attachment or soft brush to clean. Wipe
the dehumidifier body with a soft damp
cloth or kitchen towel.
Remove the ABS filter frame. If the optional carbon filters are fitted, remove them from the frame and hoover
gently approximately every 2-3 weeks.
If the mesh filter is dirty hoover it, if it is heavily soiled wash it with warm soapy water and dry thoroughly before
reinserting it in the unit.
When filter cleaning is finished and filters are dry placed them back into the unit.
NOTE: While the carbon filter is optional never run the unit without the mesh filter frame correctly inserted.
2. CLEAN THE WATER TANK
Every few weeks, clean the tank to prevent the growth of mould, mildew and bacteria. Partially fill the tank with
clean water and add a little mild detergent. Swish it around and then empty the tank and rinse.
NOTE: Do not use a dishwasher to clean the tank. After cleaning and drying, the tank must be reinserted securely
into dehumidifier in order to restart operation.
END OF SEASON MAINTENANCE
1. Empty and clean the water tank.
2. Clean the unit and the filters as per the cleaning procedure above.
3. Coil the power cord on the special cord storage rest at the back of the unit.
4. Cover the unit and keep it in a dry place.