User Manual

OSC. (oscillating function)

There are three different directions, 45, 90 degree and swing, the louvers will

move in swing mode or be fixed in selected position. Use 45 degree or swing

for Laundry mode

UV (UV light , air purifier function)

To select "UV", press the "UV" key and the light will come on. Germicidal UV

light is destroying germs, bacteria, fungi improving indoor air quality

HUMIDITY SETTING

Press UP / DOWN key to select the desired relative humidity level, default

relative humidity is 55%. Relative humidity 35% is selected, the compressor

will not stop until water tank full.

TIMER (timer function)

Press timer to program time. "TIMER" light comes on while timer is

programmed. Before programming make sure that the timer function has not

been activated (the light must be off). The following timer programs are

available.

a) Delayed power-on function (the appliance is in stand-by status) USE key

"UP" and "DOWN" to set the time period (0~24 hours) The appliance will start

once time reaches set value.

b) Delayed power-off function (whilst the appliance is running) The appliance

will stop once time reaches set value.

INTELLIGENT DEFROST

The appliance will defrost automatically as programmed once the coil sensor

detects temperature is too low, and the defrosting indicator will light up at

the same time. Once defrosting has finishes, the appliance will recover to

previous running mode.

TANK-FULL

If the water tank is full, the indicator light comes on and flashes.

PLASMA IONISER (ionization function)

To select "Ion", press the "ION" key and the light will come on. The ionizer can

refresh the air while killing viruses, dust mites, mould and airborne allergens

Optional carbon filter (air purification function)

Take out the carbon filter from bag and insert it on the filter. It is suggested to

hoover the carbon filter every 2-3 weeks and change them every 3-6 months

to always keep the room fresh and odor free.

Humidity Level & Timer 2 digit display

The led indicator performs the following functions: 1. When the unit is plugged in, it will indicate

the room humidity level 2. When the humidity level is selected, it will indicate the set humidity

3. When the start / stop timer is programmed will show the set timer

Notes: When humidity level is outside the normal operational parameters will show LO/HI. If ambient

humidity is lower than 20%, it will show “LO” If ambient humidity is higher than 90%, it will show “HI”