Instruction Manual

8
TIMER
TIMER Button
Press the TIMER button to program the timer. When the timer is activated the
"TIMER" light will be illuminated. Before programming the timer, ensure the
timer function has not been activated (the light must be off). The following
timer programs are available.
DELAYED POWER-ON FUNCTION: With the appliance in stand-by, press
the TIMER button, then use the UP and DOWN buttons to set in how many
hours time you require the unit to start (0~24 hours).
DELAYED POWER-OFF FUNCTION: While the appliance is running with the
desired settings, press the TIMER button, then use the UP and DOWN
buttons to set in how many hours time you require the unit to stop (0~24
hours).
SLEEP
SLEEP Button
Press the SLEEP button to enter sleep mode. While in sleep mode the sleep
indicator will be illuminated, but all other indicators will turn off. The unit will
run in low fan speed. To turn off the sleep mode, press the SLEEP button
again.
HUMIDITY
INDICATOR
HUMIDITY INDICATOR
When the appliance is started, the indicator light will turn on automatically.
The indicator light colour will change according to the humidity condition
RED: High humidity, RH≥70%
ORANGE: Above ideal humidity, 70%> RH ≥60%
GREEN: Ideal humidity, RH<60%
The ”Humidity Indicator” can be turned on and off by holding the SPEED button
for 3 seconds.
Note: It can take around 2 minutes after the humidity has changed into a
different colour bracket for the indicator will change the colour e.g. if humidity
drops to 55% may take 2 minutes before the indicator changes to green.
DEFROST
INTELLIGENT DEFROST
The appliance will defrost automatically when the coil sensor detects that the
internal temperature is too low. During defrosting the indicator will light up.
Once the defrost cycle has finished, the appliance will return to the mode that
was previously operating.
TANK FULL
TANK-FULL
When the water tank is full, the TANK FULL indicator light will flash, and the
unit will stop operating. Once emptied and replaced, the appliance will
resume operation.
OPTIONAL CARBON AND HEPA FILTERS (Air purification function)
Insert the filters into the filter housing. It is suggested to hoover the filters
every 2-3 weeks and change them every 3-6 months as this will help to
ensure the room is kept fresh and odour free.