User Manual

8
`
TIMER
Press the TIMER button to program the timer. When the timer is activated
the "TIMER" light will be illuminated. Before programming the timer,
ensure the timer function has not been activated (the light must be off).
The following timer programs are available.
DELAYED POWER-ON FUNCTION: With the appliance in stand-by,
press the TIMER button, then use the UP and DOWN buttons to set in
how many hours time you require the unit to start (0~24 hours).
DELAYED POWER-OFF FUNCTION: While the appliance is running
with the desired settings, press the TIMER button, then use the UP and
DOWN buttons to set in how many hours time you require the unit to
stop (0~24 hours).
INTELLIGENT DEFROST
The appliance will defrost automatically when the coil sensor detects
that the internal temperature is too low. During defrosting the indicator
will light up. Once the defrost cycle has finished, the appliance will return
to the mode that was previously operating.
TANK-FULL
When the water tank is full, the TANK FULL indicator light will flash, and
the unit will stop operating. One emptied and replaced, the appliance will
resume operation.
OPTIONAL CARBON FILTER (Air purification function)
Remove the carbon filter from the bag and insert it on the filter housing. It
is suggested to hoover the carbon filter every 2-3 weeks and change it
every 3-6 months as this will help to ensure the room is kept fresh and
odour free.
HUMIDITY LEVEL & TIMER 2 DIGIT DISPLAY
The led indicator performs the following functions:
1. When the unit is plugged in, it will indicate the humidity level of the room.
2. When the UP and DOWN buttons are pressed, it will indicate the desired
humidity currently set.
3. When the timer is programmed will show the duration.
Notes: When humidity level is outside the normal operational parameters will show LO/HI. If ambient humidity is lower
than 20%, it will show “LO” If ambient humidity is higher than 90%, it will show “HI”