Manualshelf

User Manual

ManualsBrandselectriQ ManualsAir Conditioning12 Litre Dehumidifier with Digital Humidistat and Air Purifier
12345678910
8
TIMER
TIMER Button
Press the TIMER button to program the timer. When the timer is activated the
"TIMER" light will be illuminated. Before programming the timer, ensure the
timer function has not been activated (the light must be off). The following
timer programs are available.
DELAYED POWER-ON FUNCTION: With the appliance in stand-by, press
the TIMER button, then use the UP and DOWN buttons to set in how many
hours time you require the unit to start (0~24 hours).
DELAYED POWER-OFF FUNCTION: While the appliance is running with the
desired settings, press the TIMER button, then use the UP and DOWN
buttons to set in how many hours time you require the unit to stop (0~24
hours).
SLEEP
SLEEP Button
Press the SLEEP button to enter sleep mode. The Sleep indicator will
illuminate, and all other lights will turn off. To exit Sleep mode, press the
SLEEP button again.
DEFROST
INTELLIGENT DEFROST
The appliance will defrost automatically when the coil sensor detects that the
internal temperature is too low. During defrosting the indicator will light up.
Once the defrost cycle has finished, the appliance will return to the mode that
was previously operating.
TANK FULL
TANK-FULL
When the water tank is full, the TANK FULL indicator light will flash, and the
unit will stop operating. Once emptied and replaced, the appliance will
resume operation.
OPTIONAL CARBON AND HEPA FILTERS (Air purification function)
Insert the filters into the filter housing. It is suggested to hoover the filters
every 2-3 weeks and change them every 3-6 months as this will help to
ensure the room is kept fresh and odour free.
HUMIDITY LEVEL & TIMER 2 DIGIT DISPLAY
The led indicator performs the following functions:
1. When the unit is plugged in, it will indicate the humidity level of the room.
2. When the UP and DOWN buttons are pressed, it will indicate the desired
humidity currently set.
3. When the timer is programmed will show the duration.
Notes: When humidity level is outside the normal operational parameters will show LO/HI. If ambient
humidity is lower than 20%, it will show “LO” If ambient humidity is higher than 90%, it will show “HI”.