Instruction Manual
8
QUICK REFERENCE GUIDE
Power Button: Press to turn the dehumidifier on and off.
Timer: Press the timer button to set the timer (1-24 hrs, start/stop timer).
While the unit is running: The number displayed will represent the number of hours the unit will run before
turning off. This will remain unaffected if unit goes in to defrost mode or the tank is emptied then reinserted.
While the unit is in standby: The number displayed represents the period in hours after which the unit
will start.
To cancel the timer: repeatedly press the timer button until 0 is displayed.
UP and DOWN Buttons: Press the up or down button during operation to amend the desired
humidity level. The relative humidity level can be set within a range of 30% to 90% in 5%
increments. When the humidity 2% below the desired humidity set the compressor will stop and the
unit will work for 3 minutes in fan only mode. When the humidity is 2% or more higher that the
desired humidity set, the compressor will restart after a 3 minutes delay.
LAUNDRY MODE:
CD20L: Press the laundry mode button to automatically start the dehumidifier in laundry mode. The
fan is set to high on laundry mode
CD10L: Use the down button to set the desired humidity to CO to operate continuously with maximum water
extraction until the tank is full.
Both units: Alternatively you can set the desired humidity to 35%-40%. Under 40% is very dry and the unit
will work until water tank is full as lower levels are not very achievable in the UK domestic environment.
Do not place clothes directly over any of the dehumidifier vents. Make sure that there is nothing blocking the
hot air exhaust air flow and for best results place the laundry within 1.5 meters of the dehumidifier.
Notes:
If a permanent drainage pipe is fitted the unit will not stop operating. Setting the desired humidity to around
35% is good for laundry mode, a quick drying boost, or in emergencies. It is not recommended for long
normal operation in a domestic or office environment.
To allow more moisture in the air, press the up button and set to a higher desired humidity (e.g. 60-70%).
We recommend setting the Humidity to 50-55%. This is great for domestic operation and dry storage
Setting the humidity to 60% is great for personal comfort and applications where 50% RH is considered
too dry
Setting the humidity to 70% is ideal for unoccupied properties or where an economical run is needed
without the need to reduce the humidity further.