Instruction Manual
Page 7 of 9 
REMOTE CONTROL 
The remote allows the same functions to be controlled as the main control panel 
on the air cooler. 
  Open the remote controller rear cover and install a CR2032 battery 
  The buttons have the same function as the main control panel 
  The remote has an effective control distance of 6 meters 
CLEANING AND MAINTENANCE 
ATTENTION:  Please  shut  off  the  unit  and  unplug  from  the  mains  before 
cleaning or performing any maintenance. 
CLEANING THE SURFACE 
Clean the plastic housing with a duster or a soft wet cloth.   
Do  not  use  chemical  solvents  (such  as  benzene,  alcohol  or  gasoline)  as  they  may  cause 
irreversible damage. Make sure no water enters the control panel.   
CLEANING THE WATER TANK   
Unplug the power cord and remove the honeycomb filter bracket. With a cloth (dipped in a 
mild detergent), wipe the water tank.    Before using the unit, the tank should be rinsed by 
filling the tank and allowing it to drain through the drain port. 
Draining the water reservoir and refilling with fresh water at least once a week will help 
reduce any mineral deposits and keep the filters clean.   
Do not run the unit in Humidify mode with stale water in the tank.   
We  recommend  emptying  the  tank  and  refilling  it  with  fresh  water  if  water  has  been 
standing in the tank for an extended period of time. 
MAINTAINING AND CHANGING THE HONEYCOMB FILTER PADS 
The appliance is supplied with Honeycomb cooling / filters pads. The cleaning frequency for 
the Honeycomb filter depends on local air and water conditions. In areas where the mineral 
content of water is high (hard water), mineral deposits may build up on the honeycomb 
cooling filter and restrict air flow. If mineral deposits remain on the Honeycomb pads, the 
filter  should  be  removed  and  washed  under  fresh  water.  For  a  deeper  clean  a  mild 
detergent should be used with a soft brush.    Once cleaned the filter should be rinsed in 
clean water before leaving to dry. 
We recommend cleaning the honeycomb filter at least every two months, depending on your 
needs. 
For best results, allow the honeycomb filter to dry after each use by turning off the COOL 
function and running the unit as a fan for 15 minutes before turning the unit off. 
END OF SEASON MAINTENANCE 
1.  Empty the tank and clean it following the instructions above. 
2.  Clean the Honeycomb pad 
3.  Store the Icepack in the water tank 
4.  Cover the unit and keep it in a dry place. 









