Instruction manual

ManualsBrandsElectra ManualsHeat PumpOU7-24T RC

Tools and Supplies Needed

(not included in kit)

• Sharp hobby knife

• Double-sided servo tape

• Round file (small)

• Velcro

Tape

• Needle-nose pliers

• Masking tape

• Wire cutters

• Black felt-tipped pen or pencil

• Phillips screwdriver

• Flat-head screwdriver (medium)not included in kit)

• 1.5mm Allen wrench

• Sanding block with fine grit sandpaper

• Ruler

• Drill

• Drill Bit: 1/8"

• 12-minute epoxy

• Rubbing alcohol

• Odorless CA

• Clear silicone sealant

Recommended Radio and

Electronic Equipment

The best choice for your airborne radio equipment would be

the JR AirPac Micro (JRPF640), which combines two JR S241

Sub-Micro servos and one JR R610 6-channel FM micro receiver

into one package. Total weight for this three-piece

package is just over one ounce.

An 8-cell 600mAh battery pack

A speed controller is included in the kit, as is the V-tail mixer

in the deluxe kit (EFLA1000). The best choice for your speed

controller is E-Flite 16-Amp Electric Speed Control (EFLA100).

If you do not have a radio that has delta mixing capabilities,

you can purchase a Delta Mixer for the standard kit (EFLA101).

Required Additional Equipment

Kit Contents

Carefully examine the contents of this kit before you start the

assembly process. It is recommended that you carefully read

through this instruction manual before you start assembly.

Fuselage

Canopy

Motor Cover

Left Wing Panel

Right Wing Panel

Vertical Fins (2)

Everons (2)

Hardware Package

Canopy hatch

Dorsal Fin

Speed Controller

(EFLA100)

Delta Mixer (EFLA101)

Motor + Gearbox

Prop Nut

Set Screw

Propeller

4 5