Service manual

16-32
APPENDIX A
SM DLF 1-A.1 GB
SAFETY PRECAUTIONS
Read the following "SAFETY
PRECAUTIONS" carefully before installation.
Electrical work must be installed by a
licensed electrician. Be sure to use the
correct rating of the power plug and main
circuit for the model to be installed.
The caution items stated here must be
followed because these important contents
are related to safety. The meaning of each
indication used is as below.
Incorrect installation due to ignoring of the
instruction will cause harm or damage, and the
seriousness is classified by the following
indications.
Carry out test running to confirm that no
abnormality occurs after the installation. Then,
explain to user the operation, care and
maintenance as stated in instructions. Please
remind the customer to keep the operating
instructions for future reference.
The items to be followed are classified by the symbols:
WARNING
This indication shows the possibility of
causing death or serious injury.
Symbol with background white
denotes item that is PROHIBITED
from doing.
WARNING
1. Use qualified installer and follow careful
this instructions, otherwise it will cause
electrical shock, water leakage, or
aesthetic problem.
2. Install at a strong and firm location,
which is able to withstand the set's
weight. If the strength is not enough or
installation is not properly done, the set
will drop and cause injury.
3. For electrical work, follow the local
national wiring standard, regulation and
this installation instruction. An
independent circuit and single outlet
must be used. If electrical circuit
capacity is not enough it will cause
electrical shock or fire.
4. Use the specified cable and connect
tightly for indoor/outdoor connection.
Connect tightly and clamp the cable so
that no external force will be acted on
the terminal. If connection or fixing is
not perfect, it will cause heat-up or fire
at the connection.
5. Wire routing must be properly arranged
so that control board cover is fixed
properly. If control board cover is not
fixed perfectly, it will cause heat-up at
connection point of terminal, fire or
electrical shock.
6. Before obtaining access to terminals,
all supply circuits must be
disconnected.
7. When carrying out piping connection, take
care not to let air substances other than
the specified refrigerant go into
refrigeration cycle, otherwise, it will cause
lower capacity, abnormal high pressure in
the refrigeration cycle, explosion
and injury.
8. Do not damage or use unspecified
power supply cord. Otherwise, it
will cause fire or electrical shock.
9. Do not modify the length of the
power supply cord or use of the extension
cord, and do not share the single outlet
with other electrical appliances.
Otherwise, it will cause fire or electrical
shock.
10. This equipment must be earthed. It may
cause electrical shock if
grounding is not perfect.
11. Do not install the unit at place where
leakage of flammable gas may occur.
Incase of gas leaks and accumulates at
surrounding of the unit, it may cause fire.
12. Carry out drainage piping as mentioned in
installation instructions. If drainage is not
perfect, water may enter the room and
damage the furniture.
13. If supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
CONTENT