Service manual

16-29
APPENDIX A
SM DLF 1-A.1 GB
NOTES
The flap automatically closes when the unit is
off.
During the heating operation, the fan speed
will be very low and the flap will be in the
horizontal position until the air being blown
out of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
Use the FLAP button on the remote control to
adjust the position of the flap. If you move the
flap by hand, the factual flap position and the
flap position on the remote control may no longer
match. If this should happen, shut off the unit,
wait for the flap to close, and then turn on the
unit again; the flap position will now be normal
again.
Do not have the flap pointed down during cooling
operation. Condensation may begin to form
around the air vent and drip down.

OPERATION
OPERATION
CONTENT