Service manual

16-5
APPENDIX A
SM DLF 1-A.1 GB
HOW TO INSTALL BATTERIES
Remove the lid in the rear part of the remote
control unit.
Insert two AAA alkaline batteries of 1,5 V-DC.
Make sure the batteries point in the direction
marked in the battery compartment.
The batteries last about six months. Depending
on how much you use the remote control unit.
Remove the batteries if you do not use the
remote control unit for more than one month.
Press the +, -, SET and CLEAR buttons
together after batteries replacement.
(This operation allows you to reset correctly all
the programs. The remote control unit is to be
set up again).
Replace the batteries when the remote
control unit lamp fails to light, or when the air
conditioner does not receive the remote control
unit signals.
The batteries of the remote control contain
polluted substances exhausted batteries must
be disposed according to the laws in force.
TEMPERATURE SENSOR SELECTOR
Under normal conditions the room temperature
is detected and checked by the temperature
sensor placed in the air conditioner.
Press the remote control I FEEL button to
activate the temperature sensor placed in
the remote control. This function is designed
to provide a personalised environment by
transmitting the temperature control command
from the location next to you. Therefore, in
using this function, the remote control should
always be aimed, without obstruction, at the air
conditioner.
OPERATION WITH THE REMOTE CONTROL UNIT
Check that the circuit breaker on the power
panel is turned ON and the STANDBY lamp is
light up.
When using the remote control unit, always
point the unit transmitter head directly at the air
conditioner receiver.
HOW TO TURN ON THE AIR CONDITIONER
Press the ON/OFF button to turn the air
conditioner on. The indicator OPERATION will
light up, indicating the unit is in operation.
NOTE
The remote control unit sends the temperature signal to the air
conditioner regularly at two minute intervals. If the signal from
he remote control unit stops for more than five minutes due to
some troubles, the air conditioner will switch to the temperature
ensor which is built into the indoor unit and controls the room
temperature. In these cases, the temperature around the remote
control unit may differ from the temperature detected in the air
conditioner position.
REMOTE CONTROL
UNIT DISPLAY
USING THE REMOTE CONTROL UNIT
USING THE REMOTE CONTROL UNIT

CONTENT