User guide

821667: VAMP2 Series User Guide

VAMP2 Series User Guide

Installation Recommendations

Unpacking

Unpack the VAMP2 Series monitor from the shipping container and

inspect all components for shipping damage. If you find any damage,

notify the shipping carrier for claims adjustments.

Compare the shipping box contents to the packing slip. Contact

Wohler’s customer support personnel about any discrepancies.

(Wohler’s contact information in on the copyright page ii, of this

manual).

Heat Dissipation

The ambient temperature inside the mounting enclosure should not

exceed 40° Celsius (104° Fahrenheit). Adjacent devices can be rack

mounted (or stacked) in proximity to the unit if the above temperature

is not exceeded. Allow a 1RU (1.75”/44.45mm) space above and below

the unit for air circulation.

Rack Mounting

You should install the monitor into a standard 19" rack and requires a

maximum of 4RU of rack space (the 2RU unit, plus 1RU above and

below). Also, install it as close to the operator’s direct viewing angle as

possible as LCD screens can appear to display anomalies outside this

viewing angle.

Important:

The heat generated by the power amplifiers, power supplies, and other

components is vented by slots in the side of the unit. Therefore, as a

safety precaution, we advise you to be sure to allow proper ventilation

on both sides of the unit.

Note:

In PAL mode operation, the LCD driver discards every

seventh line of active video so an entire video frame fits

within the display screen. This is normal for most LCDs

currently on the market.