User guide

821667: VAMP2 Series User Guide

VAMP2 Series User Guide

Front Panel Features

• Headphone Jack (1/4” Connector): Select the headphone audio

sources as you would for the internal speakers. When you plug in

headphones, the internal or external speakers will mute.

• Tint (TNT): Turn this potentiometer to adjust the color hue of the

video image (for NTSC signals only).

• Chroma (COL): Turn this potentiometer to adjust the color

saturation of the video image.

• Brightness (BRT): Turn this potentiometer to adjust the brightness

of the video image.

• Contrast (CNT): Turn this potentiometer to adjust the contract of

the video image.

• LCD Video (TFT): This screen displays input video sources.

• SDI Group Select (Push Button): This button selects the SDI group

(1, 2, 3, or 4) for monitoring when

Audio Source select button is set

to SDI or set to Tracks Video, and SDI is the video source. One of the

four LEDs will glow green to indicate the selected group.

• Audio Analog/AES Select (Push Button and Indication LEDs):

These two push buttons, AUX 1 and AUX 2, toggle between the

AES and analog (ANLG) inputs for the corresponding AUX 1 and

AUX 2 input sections on the rear panel. When the analog input is

selected, the LED is not lit. When the AES input is selected, the LED

glows green.

• Balance (Rotary Potentiometer): This control pans the volume

balance between the left and right speakers. If you adjust the

balance hard to the left or right, the system retains a slight Left/

Right channel mix so phase discrepancies remain audible.

• Audio Source (Push Button and Indication LEDs): This push

button steps through the four audio sources below:

• SDI: Monitors the audio de-embedded from the SDI inputs

on the rear panel.

• AUX 1: Monitors the audio input to the AUX 1 (analog or

AES) inputs on the rear panel.

• AUX 2: Monitors the audio input to the AUX 2 (analog or

AES) inputs on the rear panel.