Specifications

VII. DIFFERENTIAL CARRIER
A. Removal of Differential Carrier
from Axle
All service of the differential carrier assembly
requires removal of the assembly from the axle
housing.
1. Remove the drain plugs and drain lubricant from
axle housing.
2. Disconnect propeller shaft at pinion yoke.
3. Refer to Section IV-E (Page 11), and remove both
inner axle shafts.
4. Attach differential carrier to a suitable roller jack.
(See fig. 42).
5. Remove capscrews and nuts holding differential
carrier to axle housing.
6. Roll differential carrier away from the axle. (See
fig. 43).
B. Installation of Differential Carrier
to Axle
1. Refer to the Differential Carrier Service Manual
for detailed service procedures.
2.
Apply a bead of liquid sealant to the differential
mounting face. (See Service Bulletin 738 407, Page
22.) Apply in the same manner as shown for the
axle flanges, a bead and a ring around each bolt
hole.
3.
4.
5.
6.
Position the differential carrier in the axle
picking up two locating studs.
Install differential carrier capscrews and stud
nuts. Tighten to the correct torque.
Connect the propeller shaft.
Assemble the Steerable Drive Ends as outlined
in Section VI.
7. Install the drain plug and fill the axle to the bottom
edge of the level hole with the appropriate
lubricant.
8.
Install the level plug.
Fig. 42
Fig. 43
housing with a suitable roller jack, (See fig. 43),
-20-