Data Sheet

Smart Machine Smart Decision
SIM800 Series_AT Command Manual_V1.09 210 2015-08-03
command.
<PDP_type> (Packet Data Protocol type)
IP Internet Protocol (IETF STD 5)
<APN> (Access Point Name) A string parameter (string should be
included in quotation marks) which is a logical name that
is used to select the GGSN or the external packet data
network. If the value is null or omitted, then the
subscription value will be requested.The default value is
NULL.
<PDP_addr> A string parameter (IP address). Format:
"<n>.<n>.<n>.<n>" where <n>=0..255
If the value is null or equals 0.0.0.0 a dynamic address will
be requested. The allocated address may be read using the
+CGPADDR command
<d_comp> A numeric parameter that controls PDP data compression
0 –PDP data compression off (default if value is omitted)
<h_comp> A numeric parameter that controls PDP data compression
0 –PDP header compression off (default if value is omitted)
Parameter Saving
Mode
AUTO_SAVE
Max Response
Time
-
Reference Note
7.2.3 AT+CGQMIN Quality of Service Profile (Minimum Acceptable)
AT+CGQMIN Quality of Service Profile (Minimum Acceptable)
Response
+CGQMIN: <PDP_type>,(list of supported <precedence>s),(list of
supported <delay>s),(list of supported <reliability>s),(list of supported
<peak>s),(list of supported <mean>s)
[<CR><LF>+CGQMIN: <PDP_type>,(list of supported <precedence>
s),(list of supported <delay>s),(list of supported <reliability>s),(list of
supported <peak>s),(list of supported <mean>s)
[…]]
OK
Test Command
AT+CGQMIN=?
Parameters
See Write Command