Data Sheet

Smart Machine Smart Decision
SIM800 Series_AT Command Manual_V1.09 241 2015-08-03
OK
ERROR
AT+CIPCCFG=
<NmRetry>,<Wa
itTm>,<SendSz>,
<esc>[,<Rxmode
>,<RxSize>,<Rxt
imer>]
Parameters
<NmRetry> Number of retries to be made for an IP packet.
<WaitTm> Number of 100ms intervals to wait for serial input before
sending the packet.
<SendSz> Size in bytes of data block to be received from serial port
before sending.
<esc> Whether turn on the escape sequence, default is TRUE.
0 Turn off the escape sequence
1 Turn on the escape sequence
<Rxmode> Whether to set time interval during output data from serial
port.
0 output data to serial port without interval
1 output data to serial port within <Rxtimer> interval.
<RxSize> Output data length for each time, default value is 1460.
<Rxtimer> Time interval (ms) to wait for serial port to output data
again. Default value: 50ms
Parameter Saving
Mode
NO_SAVE
Max Response
Time
-
Reference Note
This command will be effective only in single connection mode
(+CIPMUX=0)
8.2.24 AT+CIPSHOWTP Display Transfer Protocol in IP Head When Received Data
AT+CIPSHOWTP Display Transfer Protocol in IP Head When Received Data
Response
+CIPSHOWTP: (list of supported <mode>s)
OK
Test Command
AT+CIPSHOWTP
=?
Parameters
See Write Command
Response
+CIPSHOWTP: <mode>
OK
Read Command
AT+CIPSHOWTP
?
Parameters
See Write Command
Write Command
AT+CIPSHOWTP
Response
OK