Data Sheet

Smart Machine Smart Decision
SIM800 Series_AT Command Manual_V1.09 20 2015-08-03
21.5 AT+SGPIO Modify difference
21.9 AT+CADC Add difference
21.10 AT+CSCLK Add difference
21.13 Add GPIO difference
6.2.52 AT+CWHITELIST Extend the scope of parameter <mode> to "0-3"
6.2.70 AT+CGPIO Add AT command
6.2.71 AT+CMEDPLAY Add AT command
6.2.72 AT+CMEDIAVOL Add AT command
8.2.14 AT+CDNSGIP Add error code
12.2 Modify max response time
17.2.1 AT+CREC Modify note
1.06 2014-10-28
19.3 Modify note
1.1 Scope of the document Add SIM800C
2.2.16 ATS0 Modify note
6.2.20 AT+CSCLK Modify note
6.2.73 AT+SNDLEVEL Add AT command
1.07 2014-12-19
21 Add differences of SIM800C
6.2.55 AT+CSGS Extend the scope of parameter <mode> to "0-2"
6.2.74 AT+ECHARGE Add AT command
6.2.75 AT+SIMTIMER Add AT command
6.2.76 AT+SPE Add AT command
17.2.1 AT+CREC Modify note
19.1
Change CME error codes from 810~824 to
600~614
1.08 2015-05-12
21.13 Add AT+ECHARGE,AT+SIMTIMER,AT+SPE
1.1 Scope of the document Add SIM800A, SIM800F, SIM800C-DS
6.2.21 AT+CENG
Extend the scope of parameter <mode> to "0-4"
and modify note
6.2.65 AT+SIMTONEX Modify note
6.2.70 AT+CGPIO Modify response value of test command
6.2.71 AT+CMEDPLAY Modify note
6.2.77 AT+CCONCINDEX Add AT command
6.2.78 AT+SDMODE Add AT command
6.2.79 AT+SRSPT Add AT command
11.2.9 AT+HTTPHEAD Add AT command
15.2.6 AT+CMMSDOWN Modify <type> parameter
17.2.1 AT+CREC Modify note
1.09 2015-08-03
19.3 Delete URC of "AT+CENG" when <mode>=3