Owner`s manual

Installation Procedure

Removing the Top Cover

Disconnect power and all cables from your K3.

Remove the nine screws to free the top cover as shown in Figure 3. After the cover is open, lift it gently to

reach the speaker wire connector. Unplug the speaker then set the top cover aside in a safe place.

Whenever you remove screws from a panel, if one screw seems too tight to loosen

without damaging it, first loosen the other screws then try again. Sometimes one screw

binds in its hole when the other screws are tightened.

Figure 3. Removing K3 Top Cover.

CAUTION:

Touch an unpainted metal ground or wear a grounded wrist strap

before touching components or circuit boards inside the K3. See Preventing Electrostatic

Discharge on page 6for more information.

K144XV Option

If your K3 does not have the K144XV 2-meter module option installed go to Replacing the Synthesizer(s) on

page 10. Otherwise, move the 2-meter module out of the way as follows: