Owner`s manual

17
If you have the K144XV option installed, hold the top cover above the K3, route the speaker wire under the
stiffener bar at the depression in the top of the K144XV module as shown in Figure 15.
Figure 15. Routing the Speaker Wire Under the Chassis Stiffener.
Plug the speaker wire into P25 on the KIO3 board at the left rear of the K3 as shown in Figure 16.
Figure 16. Plugging the Speaker Wire into the KIO3 Board.
Position the top cover on the K3. Note that the tab on the back center goes under the rear lip of the K3 rear
panel. Secure the top cover with the nine 4-40 3/16” (4.8 mm) black flat head screws you removed earlier (see
Figure 3on page 8for the screw locations).
REPLACE ALL THE SCREWS!
The K3's chassis has excellent rigidity despite its light weight. The screws that hold the top
cover in place are an important part of the structural design. Please be sure to replace all the
screws and verify they are tight whenever you replace the cover or other panels