Owner`s manual

If your K3 has the KRX3 sub receiver, install the auxiliary synthesizer as follows:

1. First attach two coaxial cables to the pc board before installing it as shown in Figure 11.

Connecting these now will simplify connecting them later in the tight space between the sub

receiver enclosure and the synthesizer.

2. With the two coaxial cables connected, install the synthesizer just as you did the main

synthesizer, using the screws supplied with the KSYN3A board and the interior tooth lock

washers you removed earlier (see Figure 10).

Do not replace the lock washers behind the KSYN3A board. Like the main synthesizer,

the board rests directly against the PEM nuts on the front panel shield.

Figure 11. Preparing to Install the Auxiliary Synthesizer.