User's Manual
TETRAPOD SPEAKER
Model (Device name)
SP-ELB001C (TETRAPOD)
Power supply voltage DC5V (USB power supply)
Communication method Bluetooth standard Version 4.2
Output Bluetooth standard Power Class 2
Supported Bluetooth profi les A2DP
Codec compatible with A2DP SBC
Maximum communication range Approx. 10m (estimated)
Maximum number of devices that
can be registered
8 devices
Continuous playback time
Approximately 4 hours *
Speaker Unit
Full range + Passive+ Tweeter
Speaker type Airtight
Maximum Output Power 1W
Impedance 4Ω
Frequency Characteristic 100Hz to 20kHz
Dimensions (W × D × H)
Approximately 160 × 140 × 150 mm
Weight Approximately 320 g
Operating environment temperature/humidity 5°C to 35°C/20% to 80%RH (without condensation)
* These values may differ depending on the environment such as the connected device, application, OS, and
transmission environment in which the product is used.
Thank you very much for purchasing this product.
This manual contains information on how to use
this product and safety instructions. Read this
manual carefully before using the product. Keep
this manual carefully in an easy to access location.
1.
Charging
To charge, connect this product to a USB AC adapter
using a commercial USB cable as shown in the image.
The LED light turns off when charging is complete.
3.
Pairing
Follow the steps below to connect your smartphone.
4.
Setting
Depending on your preference, use the included stand
for better sound quality.
2.
Switching On
Slide the power switch
to turn the power ON.
ON
OFF
TETRAPOD
Bluetooth
Bluetooth
1
2
Set
Bluetooth
to "ON"
Tap
"TETRAPOD"
in the
device list
Switch the power switch to ‘On’ to enter pairing mode.
Search for this product (TETRAPOD) using
your smart-phone or other connected device
and register it.
When the LED light fl ashes twice within 7 seconds and
a ‘wave sound’ is heard, pairing is complete.
When connection fails
When the reason for the connection failure is unknown, reset this
product and try again. To reset, remove the rubber foot on the
underside of the power switch and push the reset button with a
thin object such as a pin.
To listen to music, use the
music application on the
connected device such as
your smartphone.
Before using this product
Be sure to observe the following precautions in order to ensure safe and correct use.
This symbol represents prohibited actions. The specifi c prohibition is represented by the
symbol.
This symbol represents cautionary items including warnings.
This symbol represents compulsion. The specifi c prohibition is represented by the symbol.
WARNING
Ignoring the following items may lead to death or disability, or damage
to property.
In the case of an abnormality.
If odour or smoke is emitting from this product, cease usage immediately and switch it
off. If charging, unplug the cable from the power supply such as the AC adapter. Cease
usage after that and contact your retailer.
Do not leave the product exposed to high temperatures.
This product is a precise electronic device. Avoid using or storing in places with high
temperature, high humidity, or long-term direct sunlight.
Never leave this product in a car. Leaving this product in cars with high internal
temperature for a long time is highly dangerous as it will lead to rupturing, burning, and/
or malfunctioning of the internal batteries. In addition, rapid changes in the surrounding
temperature may lead to malfunction caused by internal condensation.
Disconnect the charging cable when charging is complete.
Also, after the necessary charging period is over and the charging has not completed,
disconnect the cable anyway. If the given charging time has been exceeded, there is a
possibility of an explosion, fire, or damage to the battery inside. Also, this may have an
impact on the battery life.
Do not use the product in a hospital or an aircraft.
Do not use in places that require a high level of safety. Doing so may cause malfunctions
in special medical equipment or the meters of an aircraft.
Do not disassemble the product.
Do not repair, modify, or disassemble the product unless instructed by this document.
Doing so may cause electric shock, fire, or burns.
Do not damage the cable that is being used for a connection.
Doing so may cause a fire or damage to the cable.
Safety Precautions
CAUTION
Ignoring the following items may lead to injury and/or damage to
property.
Do not use or store the product near water.
This product is not waterproof. When the inside of the product becomes wet, it may
cause damage, fire, or electric shock.
Do not store the product within reach of small children.
Doing so may lead to accidents, such as accidental ingestion.
Avoid using or storing the product where vibrations, external impacts, strong
magnetic forces, or static electricity may occur as the product is a sensitive
electronic device.
Follow the instructions in the user's manual for each of the connected devices.
This product is capable of wireless communication with PCs and mobile phones.
Setting procedures and precautions may differ depending on the device. Read the
user's manual of each device carefully and follow the instructions.
Additional matters to pay attention to.
• Do not place the product where static electricity may occur easily or in very dusty places.
• If this product becomes dirty, wipe clean with a soft cloth containing a small amount of water or diluted
neutral detergent. Do use benzene or thinners as this may result in deformation or discoloration.
Precautions regarding radio waves
The band of frequencies used by this device are used to operate local wireless base stations (wireless
stations that require a licence) and designated low-power wireless stations (wireless stations that do
not require a licence) for the detection of moving objects on factory production lines in addition to mi-
crowave ovens and other industrial/scientifi c/medical devices.
Before using this device, make sure that local wireless base station and designated low-power
wireless stations for the detection of moving objects are not being operated.
If this device has created radio wave interference for a local wireless base station for moving
object detection, quickly change the frequency that is used or stop radio wave emission and
then contact the retailer from whom you purchased the product for information on how to
avoid interference (such as installing a partition).
If this device interferes with the radio waves of a specifi ed low power radio station for detect-
ing mobile objects, or if there are any other problems, contact the retailer from whom you pur-
chased the product.
Frequency band used: 2.4GHz
Modulation method: Frequency Hopping Spread Spectrum (FHSS)
Estimated Impedance Distance: approx. 10m
Frequency change: All bands useable and possible to avoid “premises radio station” or “specifi ed
low power radio station” bands
Regarding the built-in battery
A battery is a consumable part that will become exhausted even when it is used properly. Bat-
tery degeneration is normal. It is not a malfunction. The batteries cannot be replaced.
When the product is stored for a long time without being used, the built-in battery loses its
capacity. A repeat charging and discharging should restore it.
When the temperature is low, the number of 'continuous using hours' will be shortened.
Regarding disposal
Follow guidance of local municipal government where you live when disposing of the product.
Enquire with your local government for the regulations.
Regarding user support
Contact for enquiry on product
A customer who purchases outside Japan should contact the local retailer in the country of
purchasefor enquiries. In “ELECOM CO., LTD. (Japan)”, no customer support is available
forenquiries about purchases or usage in/from any countries other than Japan. Also, no foreign
language other than Japanese is available. Replacements willbe made under stipulation of the
Elecom warranty, but arenot available from outside of Japan.
Limitation of Liability
• In no event will ELECOM Co., Ltd be liable for any lost profi ts or special, consequential, indirect,
punitive damages arising out of the use of this product.
• ELECOM Co., Ltd will have no liability for any loss of data, damages, or any other problems that may
occur to any devices connected to this product.
Regarding personal data management
Except for where the request for release of customers’ information obtained via user registration,
repair requests, product inquiry and other services to the related companies or providers dealing
with enquiries regarding the repaired product or after-sales support, quality improvement of the
product or service, market survey and other such services is legally approved as a legal duty
defi ned by the judicial and administrative organisations, personal data will not be disclosed to
any third party without the consent of the customer. All customers’ personal data is managed
and stored with the utmost care.
• If connected with a device unintentionally, turn off the device and try again.
• If a previously paired device is nearby, the speaker automatically reconnects to the device.
When switching it off, a
‘wave sound’ will be heard.
Blinks in blue twice
every 7 seconds.
(Pairing complete)
7 seconds
Blinks red and blue
alternately
(Pairing mode)
Commercial USB cable
USB
Type-C
To the USB port on the
USB AC adapter
Power Switch
Rubber feet
Reset button
Power Switch
• The copyright of this Manual belongs to ELECOM CO., LTD.
• Do not copy/transfer part or all of this Manual.
•
•
•
If you have any suggestions or doubts about this Manual, please contact the retailer whom you
purchased the product from.
The specifications and appearance of the product are subject to changes without prior notice
for improvement purposes.
We shall bear no responsibility for any device failure or malfunction of other devices resulting
from the use of this product.
• To export the part of this product applicable to strategic goods or services, export or service
trading permission according to foreign currency laws is necessary.
• The Bluetooth
®
wordmark and logos are registered trademarks owned by Bluetooth SIG, Inc.
and any use of such marks by ELECOM CO., LTD. is under licence. All other trademarks and
trade names belong to their respective owners.
• Any other product names and company names in this manual are trademarks or registered
trademarks of their respective holders.
Trademark and name of the manufacturer:
ELECOM CO., LTD.
www.elecom.co.jp/global/
ELECOM Singapore Pte. Ltd
Blk 10, Kaki Bukit Avenue 1,
#02-04 Kaki Bukit Industrial Estate, Singapore 417942
TEL : +65 6347 - 7747
FAX : +65 6753 - 1791
ELECOM Korea Co., Ltd.
Dome-Bldg 5F, 60, Nambusunhwan-ro 347-gil, Seocho-gu,
Seoul, 06730, South Korea
TEL : +82 (0) 2 - 1588 - 9514
FAX : +82 (0) 2 - 3472 - 5533
www.elecom.co.kr
ELECOM Sales Hong Kong Ltd.
2/F, Block A, 2-8 Watson Road, Causeway Bay, Hong Kong
TEL : +852 2806 - 3600
FAX : +852 2806 - 3300
email : info@elecom.asia
ELECOM (SHANGHAI) TRADING Co.,Ltd
Room 208-A21, 2nd floor, 1602 Zhongshanxi Road,
Xuhui District, Shanghai, China, 200235
TEL : +86 021-33680011
FAX : +86 755 83698064
Importer UK Contact :
Around The World Trading Inc.
Afon Building 223, Worthing Road
Horsham, RH12 1TL, United Kingdom
TETRAPOD SPEAKER
Manual, Safety precautions, and Compliance with regulations
1st edition, July XX, 2020
©2020 ELECOM Co., Ltd. All Rights Reserved.
MSC-SP-ELB001C ver.111
A customer who purchases outside Japan should contact the local retailer in the country of pur-chasefor
enquiries. In “ELECOM CO., LTD. (Japan)”, no customer support is available forenquiries about
purchases or usage in/from any countries other than Japan. Also, no foreign language other than
Japanese is available. Replacements willbe made under stipulation of the Elecom warranty, but arenot
available from outside of Japan.
FCC ID:
YWO-SP-ELB001C
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE; This equipment has been tested and found to comply with the limits for a Class B Digital
Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and
can radiated radio frequency energy and, if not installed and used in accordance with the instruction,
may cause harmful interference to radio communication. However, there is no grantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by tuning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
NOTICE: The manufacture is not responsible for any radio or TV interference caused by unauthorized
modifiation to this equipment. Such modifications could void the user's authority to operate the
equipment. In order to make improvements to this product, the design and specifications are subject to
change without prior notice.
Compliance status www.elecom.co.jp/global/certification/
WEEE Disposal and Recycling Information
This symbol means that waste of electrical and electronic
equipment (WEEE) should not be disposed as general
household waste. WEEE should be treated separately to
prevent possible harm to the environment or human health.
Consult your retailer or local municipal office for collection,
return, recycle or reuse of WEEE.
Please see the current state of RoHS compliant:
Xin tham khảo theo hiện trạng tuân thủ RoHS:
www.elecom.co.jp/global/certification/
Importer EU Contact :
Around the World Trading, Ltd.
5th floor, Koenigsallee 2b, Dusseldorf,
Nordrhein-Westfalen, 40212, Germany