Product Guide

9elecbrakes.com
The trailer wired leader (TWL) can be spliced into the
loom or joining the to the wires in the trailers plug.
It’s recommended that any spliced joins are sealed
with a shrink tube and soldered to provide the best
possible connection.
Measure the length of the leader to gauge where to
mount the unit.
When mounting the device avoid placing it in metal
tool boxes or surrounding the device by metal.
Mounting contrary to this advice may result in poor
signal connectivity.
The device has a bre reinforced case and a urethane
resin ll to protect the electronics.
Mounting to the inside or outside of the draw bar is
recommended.
What you’ll need:
• Drill
• 2-3mm drill bit
• No. 2 Phillips driver
• Tape measure
• Marker
• Lubricant
User guide8
1. Pre-drill holes using 2-3 mm drill. 2. Lubricate screws before tightening.
02.
Attaching the Unit to the Trailer
3. Place unit in correct location and attach with self-taping
screws, No.2 Phillips driver bit and a cordless drill.