Product Guide
22 23User guide elecbrakes.com
1. Select the tech page icon
at bottom of home screen
(next to settings).
System Check Set Mounting Angle
2. Headlight Voltage
between >10 and <32.
When brake pedal pressed the
voltage indicator responds with
voltage value.
Note: If Auxiliary power source is
connected, voltage input should
be displayed and light indicator
illuminated.
Elecbrakes can be mounted facing in any direction (refer mounting orientation)
but requires this angle to be conrmed in the unit for operation.
• Connect the trailer and take for a drive. On a straight road increase
speed to at least 50 kph and press moderately on the brake pedal
for 4-5 seconds.
• The angle the unit is mounted at will be measured, and an installation angle set.
• To conrm installation angle is set go to:
Settings Page > Device > Angle
After braking the angle should be set between 0-360
• If the angle is not set after the rst braking effort, continue braking the
tow vehicle and trailer. The Elecbrakes controller will assess each brake
response and set the angle for you. This could take 405 brake responses.
• The mounting angle is continuously measured and rened on every
application of the brakes.
Installation is now complete.