User guide

Figure 97. LAN Menu — LAN Adapter Settings
Enable Gateway – enables/disables the network gateway mode for the second network
adapter:
• Off – the gateway mode is disabled
• DHCP and NAT – the automatic address setting (for connected network
devices) and the network address translation are enabled
• Bridge – the bridge mode is enabled (the STB operates as a two-port router)
• NAT – only the network address translation is enabled (the network
parameters of connected devices must be set manually)
Batdwidth Limit – limits network traffic for the second adapter. This option is unavailable,
if the gateway mode is disabled. In the bridge mode the bandwidth limitation is available if
only the connected device address is specified explicitly. To disable the traffic limitation, the
zero value must be set.
Client MAC Address – specifies the MAC address of the device connected to the second
network adapter. This option is available, if the bridge mode and traffic limitation are
enabled. If the value is not specified or incorrect, the network traffic is blocked.
Address Mode 2 – specifies the address receiving mode for the second network adapter:
• DHCP – address is received automatically (if it is possible)
• Static – address is specified by user
IP Address – specifies the STB IP address (second network adapter)
Renew IP-address Settings – applies the second network adapter settings
The Wireless menu allows settings of a wireless network adapter (is not included into the
STB delivery set).
iTelec STB 82x 76 User Guide