User guide

The Clear Current Channel List command removes all items from the configured channel list.
After the list clearing the channels must be configured again using the Scan for Channels or
Scan Custom Frequency commands.
The Reset Channel Numbers command allows reordering of the configured channel numbers.
This command does not clear the channel list.
The DVB Signal Inversion, DVB Scan Speed, and Extended Scan of DVB Channels
parameter values are set using the OK button repeated pressing.
To set the Lower DVB Frequency Limit, Upper DVB Frequency Limit, and DVB
Frequency Step parameter values, use the remote control numeric buttons. Confirm the typed
value with the F2 (green) button or abandon it with the F1 (red) button.
In the extended scanning mode the channel scanning is performed in extended frequency range
(not only for reference frequencies). This option increases the scanning time.
The DVB Frequency Step parameter has an influence on the scanning speed. The default
parameter value is 8 MHz. The large value can cause missing of some channels.
2.7.9.7 Network
The Network settings menu allows you to set the network parameters.
Figure 95. Network Settings
The Network menu is divided into the following submenus:
iTelec STB 82x 74 User Guide