User guide

• The delivery set checks with this User Guide
• The STB is not mechanically damaged
• Connectors are clean
• Cables are serviceable
2.3 Operability Test
To test the STB operability, do the following:
Attention! Switch off all devices (STB, TV set, etc.) before connecting or disconnecting any
cables.
• Plug a DVB-T antenna cable (for instance, any TV aerial for decimetric waves) into
the STB DVB-T RF IN connector
• Connect one of the STB video outputs (S-VIDEO or VIDEO OUT) with the
corresponding television set input
• Connect the STB analog stereo output jacks (white and red) with the television set
audio input
• Connect the STB WAN socket to the local network outlet (Ethernet) using the
supplied patch cord
• Connect the power lead from the power supply to the STB DC IN-12V input and
plug the power supply mains cord to the wall outlet (220 V, 50 Hz)
• Switch on the STB with any button on the front panel or using the remote control
Attention! Before the remote control use, insert two batteries type AAA or LR03 (are not
supplied with the STB) into the battery compartment, taking care to observe the correct
polarity.
2.4 Troubleshooting
The following table describes possible malfunctions and troubleshooting methods.
Table 2. Troubleshooting
Malfunction and it Signs Probable Cause Troubleshooting Method
Does not light Power indicator on the
front panel after the power supply is
switched on.
The power supply mains
cord is not plugged to the
wall outlet
Check the power supply
connection to the wall outlet.
The power supply unit
does not function properly.
Replace the power supply unit or
refer to the manufacturer.
The remote control doer not operates. The power supply is not
turned on.
Check the STB power supply.
iTelec STB 82x 10 User Guide