Manualshelf

User guide

ManualsBrandsElecard ManualsMedia ConverterConverter Studio
61626364656667686970
Elecard Converter Studio 63 User Guide
track. Click the required parameter and type the value.
Other parameters are common for the whole stream.
The following table describes controls of the Multiplexing Advanced Settings dialog.
Table 13. Multiplexing Advanced Settings Controls
Control
Description
Transport Stream ID
This is a 16-bit field. It identifies the transport stream among other streams
over the network. The value is defined by the user (ISO/IEC 13818-1).
PCR Interval
This option is available only for Transport Stream. Allows the user to specify
the time distance between two consecutive Program Clock Reference stamps.
Use Padding
Allows the stream expanding with padding packets to provide the specified
constant bitrate.
Required Bitrate
Sets the total bitrate of transport stream. If this value is not specified, the
stream bitrate is calculated as sum of bitrates of all multiplexed streams.
Stream ID
This is a 13-bit field that indicates the type of the packet payload data.
Stream PES ID
Specifies the type and number of elementary stream in Program Stream. In
Transport Stream it may be set to any valid value that correctly describes the
elementary stream type (defined in table 2-19 ISO/IEC 13818-1). In Transport
Stream elementary stream types are defined in Program Specific Information
(page 44 ISO/IEC 13818-1).
Correct Bitrate
This option allows the user to specify the stream real bitrate, if the stream
declared bitrate is not correct.
Language
Specifies language of audio or subtitle tracks.
Shift (ms)
Specifies time shift of the track beginning. Is used for elimination of
synchronization problems.
For multiprogram stream creation click multiplexing area to open the shortcut menu and select the
Create program command. By using this menu you can also delete or change the program
parameters.
To set Program number and Program id use the Program Parameters window. This window is
displayed when the program parameters are created or changed.
Figure 19. Program Parameters
The following table describes Program Parameters controls.