User manual
MANUAL ELDES ESIM264 V2.1 13
1. The system will initiate the Entry Delay countdown (by default – 15 seconds) after the user has entered the
secured area. Entry Delay countdown is intended for user to enter a valid user password before the alarm is
caused.
2. To disarm the system or turn o the alarm, send the following SMS message to the system‘s phone number
from any out of 5 preset user phone numbers:
SMS text:
XXXX_DISARM1
or XXXX_DISARM2 or XXXX_DISARM1,2
Value: 1 – partition 0; 2 – partition 1; 1,2 – both partitions
Example: 1111_DISARM1
3. After the system is successfully disarmed, it will reply with conrmation by SMS message to the user phone
number who sent the SMS message.
1. Leave the secured area.
2. To arm the system, send the following SMS message to the system‘s phone number from any out of 5 preset user
phone numbers:
SMS text:
XXXX_ARM1 or XXXX_ARM2 or XXXX_ARM1,2
Value: 1 – partition 0; 2 – partition 1; 1,2 – both partitions
Example: 1111_ARM1
3. After the system is successfully armed, it will reply with conrmation by SMS message to the user phone number
who sent the SMS message.
4. When attempting to arm the system in case of violated zone / tamper presence, the system will reply with vio-
lated zone / tamper number. For more details, please refer to chapter 2.5 Bypassing & Unbypassing Violated
Zone.
3.2.2 Arm by SMS Message
Fig. No. 8
User
ESIM264
SMS
SMS
SMS
3.2.3 Disarm & Turn o the Alarm by SMS Message
Fig. No. 9
User
ESIM264
SMS
SMS
SMS