User manual

26
ATTENTION!
Valueeldsareseparatedbycommas.MaximumSMSlengthis160characters.Onlyonezoneparameterscanbeconguredby
one SMS message.
Examples of using SMSEXTRA command.
Suppose in all cases initial parameters were not changed and are manufacturer default.
1. Example of SMS message conguring Z1 input:
This message congures Z1 input parameters.
SC15 means that during the alarm SMS message sending is disabled for users NO1 and NO5. As per manufacturer default settings
SMS sending is preset for all users, therefore users NO2, NO3 and NO4 SMS messages will still be delivered.
CC25 means that during the alarm calling function is disabled for users NO2 and NO5. As per manufacturer default settings, calling
function is preset for all users, therefore users NO1, NO3 and NO4 will still be called.
SE1234 means that SMS restore message sending is enabled for users NO1, NO2, NO3 and NO4. This means that when Z1 is restored
after previous trigger, these users will be informed about this restore by SMS message. However, alarms and restore SMS messages
will be sent until the rst successful delivery. To enable compulsory message delivery to all users you should use the command
XXXX_SMSALL:ON, as described in chapter 3.7.
CE4 means that during Z1 restore only user NO4 is called.
LE1meansthatinputtypeforzoneZ1willbeinverted,i.e.thepreviousNOischangedtoNC(normallyclosed).Thismeansthatthe
alarm is triggered only when the signal disappears, and the restore is announced only in the case when the signal appears.
DV900 means that Z1 input is triggered only if the signal is suspended at least for 900ms. Please note that input type was inverted
toNC.(IfinversionwasnotpossiblethisDV900commandwouldmeanthatthesignaltransmittedmustnotbeshorterthan900ms.)
2. Example of SMS message conguring Z2 input:
This message congures Z2 input parameters.
IE1 means that impulse counting mode is enabled for Z2 input.
IC555 means that the users will receive the alarm when 555 impulses are transmitted to the input. Immediately after the alarm the
counter resets and starts counting impulses until their number reaches 555.
To see the preset values for any command send SMS message with the same format that you use when changing parameters; only
Value structure will have no value:
XXXX – user password.
Zn – possible values Z1,Z2,Z3,Z4,Z5. Dene the number of the zone being changed.
ValuestructureisCn,whereCniscommandname(2letters).
E. g. XXXX_SMSEXTRA:Z2:SS,SC,CC,SE,SD
XXXX_SMSEXTRA:Z1:SC15,CC25,SE1234,CE4,LE1,DV900
XXXX_SMSEXTRA:Z2:IE1,IC555
XXXX_SMSEXTRA:Zn:Value1,Value2,……,ValueN
ESIM 251
XXXX_
SMSEXTRA:
Z2:SS,SC,
CC,SE,SD
FOR ADVANCED USERS
All these features can be congured using program “ELDES Conguration Tool“