User manual

20
FOR ADVANCED USERS
All these features can be congured using program “ELDES Conguration Tool“
E. g. 3.
The user wants to connect ESIM251 system to the heating system of the house.
As per factory default settings C1 output control via calls is disabled for all users, it is necessary to enable this feature and to set the
users who will be able to control the output – in this case it is user NO1. Besides it is also necessary to set relay status for user NO1
when he/she calls the system. In this case you must set the system so that the relay is activated after one call and deactivated after
anotherone(Toggle)andsoon.UserNO1needstoenableconrmationcallfeatureandsetthelengthparametersforthatcall.To
dierentiate whether the relay was enabled conrmation call will be set to ring for 3 seconds and the conrmation call will ring for
10 seconds when the relay is disabled.
a)FirstofallESIM251systemrelayoutputC1hastobeconnectedtotheconnectorsofheatingsystemcontrolunit.
b) ThefollowingcongurationSMSmessagemustbesenttoESIM251system:
where CE1 means that C1 relay control via call is enabled for users NO1.
CS1 means that conrmation call feature is enabled for user NO1 after C1 relay status changes.
CT113 means that user NO1 will receive a conrmation call when the relay gets activated and call duration is 3 seconds.
CT1010 means that user NO1 will receive a conrmation call when the relay is deactivated and call duration is 10 seconds.
MS12 means that Toggle mode is activated for user NO1 which means that relay status is changed with every call.
Task No1:
 Conguringthesystemsothathouseheatingsystemisturnedonandturnedobytheuser(NO1)viafreecall.Thisusershould
also receive free information abut successful turning on or turning o of the heating system.
User
NO1
User
NO2
Flood detector
Heating
Controller
ESIM151
Conrmation
Call
3sek/10sek
Control
Call
XXXX_SMSEXTRA:COC:CE1,CS1,CT113,CT1010,MS12