User manual

USER MANUAL ELDES ESIM251 V1.0 15
FOR ADVANCED USERS
All these features can be congured using program “ELDES Conguration Tool“
Task NO2:
 Conguringthesystemsothatthejanitor(NO3)isinformedaboutthetriggeredperimetersensorofeldterritorybySMSmessa-
ge and a call; and when the sensor is reset, the janitor receives SMS message only.
As per factory default settings SMS message sending feature in the case of alarm is enabled for all users until the rst successful
delivery of the SMS message, it is necessary to remove the users that should not receive any alarm messages. Besides, as per factory
default settings, calling feature in the case of alarm is also enabled for all users therefore call function must be disabled for all users
exceptuserNO3.SMSmessagesendingfeaturemustalsobeenabledforuserNO3wheninputZ3isrestored.
a)Firstofallsecuritycentralunitmustbeprogrammedinthewaysothatwhenterritorysecurityperimetersensoristriggered
PGM3 is activated.
b)PGM3isconnectedtoESIM251inputZ3
c) ThefollowingcongurationSMSmessagemustbesenttoESIM251system:
where SC1245 means that alarm SMS message sending to users NO1, NO2, NO4 and NO5 is disabled after Z3 is triggered. CC1245
means that alarm call feature is disabled for users NO1, NO2, NO4 and NO5 after zone Z3 I triggered. SE3 means that SMS message
sending feature is enabled for user NO3 after Z3 input is restored.
XXXX_SMSEXTRA:Z3:SC1245,CC1245,SE3
Alarm
SMS/Calls
Restore
SMS
PGM3
Enterprise A Enterprise B
ESIM151
PIRPIR
Director A
NO1
Director B
NO2
Worker A
NO4
Worker B
NO5
Janitor
NO3
Janitor
Alarm system
GATES