User manual

10
3. Additional System Capabilities
3.1 Renaming alarm, restore text and controller names
Manufacturer initially set the following zone and controlled output names:
Zone1, Zone2, Zone3, Zone4, Zone5, OUTPUT1
E. g. if during the alarm Z1 zone was triggered, the system sends SMS message with the text: Zone1
AlarmtextchangesaremadebysendingthefollowingSMSmessage:
E. G. XXXX_Z1:Intrusion though the door;Z2:Fire sensor triggered;
Textscanbechangedallatonceforallzones,severalofthemoronebyone.Maximumtextforonezone
is24characters.Thespaceisequaltoonecharacter.Eachnewtextmustbefollowedbyasemicolon.As
semicolonisusedforseparatingtextsfordierentzones,itcannotbeusedinthemiddleofalarmtexts
itcanonlybeusedattheend.Textscannotbethesameascontrolcommands.
Triggered zone restore text
If you want to be notied by an SMS message when the triggered zone is restored Restore mode must be turned on. The mode is
turned on by sending a particular SMS command. Please refer to chapter 3.9 or conguration program.
ZonerestoretextischangedbysendingthefollowingSMSmesaage:
Controller name can be changed by sending the following SMS message:
Controller name cannot be followed by a semi colon. You cannot change zone names and controller
names at the same time.
E. g. XXXX_C1:PUMP
3.2 Enabling/Disabling Zones
NOTE
Manufacturer set all the zones activated, i. e. in mode ON.
USEFUL INFORMATION
The zones can be enabled/disabled together or separately one by one.
Enabling Zone
Any zone can be enabled by sending the following SMS message:
XXXX_Z1:NewAlarmText;Z2:NewAlarmText;Z3:NewAlarmText;Z4:NewAlarmText;Z5:NewAlarmText;
XXXX_ZR1:NewRestoreText;ZR2:NewRestoreText;ZR3:NewRestoreText;ZR4:NewRestoreT
ext;ZR5:NewRestoreText;
XXXX_C1:NewControllerName
XXXX_Z1:ON;Z2:ON;Z3:ON;Z4:ON;Z5:ON;
ESIM 251
XXXX_Z1:
trespaced;
Z2:
triggered
re
detector;
ESIM 251
XXXX_C1:
PUMP