Operating instructions

BIG 10 Bridge

Version: 2013/04/15

3 Configuration of the BIG 10 router via inbuilt graphical user interface

(GUI)

The BIG 10 can easily be configured using its in-built graphical user interface. This can be

done using a standard Internet browser (Firefox, Internet Explorer, Safari), which are availa-

ble at most modern computer today.

To access the Web-GUI proceed as follows:

1. Make sure, that the network settings of your computer allow the automatic IP-address

assignment. Please ask you network administrator for further details.

2. Connect your computer with the LCT interface of the BIG 10 using a standard Ether-

net cable.

3. After connecting the device, the computer will be assigned by an IP-address automati-

cally.

It is as well possible to use a static IP-address. For this apply your computer the following

data:

Pre-Settings

User-Settings

Address Range

192.168.1.2 bis 255

Subnet Mask

255.255.255.0

Gateway Address

192.168.1.1

Open now your Web-Browser and type the following in the address field:

http://192.168.1.1

Note Make sure, that your proxy settings are switched off or set correctly.

The following login window appears after successful connect:

Figure 5: Login window

The login is allowed for the following user:

 The „normal user“ can mainly access status information of the device.

 The „administrative user“ can access all settings of the device.