Operating instructions

BIG 10 Bridge

Version: 2013/04/15

3. If required, a Service-PC can be connected to the LCT port, using a standard Ethernet

cable.

4. Finally use the enclosed plug-in power supply module to connect the socket „12V

DC“ of the BIG 10 to the electricity network. Do not use any other power supply

module than the one included in delivery. The use of other power supply units will re-

sult in the loss of the CE conformance and exclude any warranty claims.

2.6 Putting into operation

After application of the supply voltage and performed self-configuration the BIG 10 is ready

for work. The complete line of the provider network to the BIG 10 will be put into operation

by your operator. It has a preset configuration or makes the required settings automatically by

auto-configuration.

Prerequisite for proper operation of your data link via the BIG 10 is the correct installation of

the network interface card to your PCs. Detailed information on this should be received in the

documentation provided by the card manufacturer. As the case may be, the following proce-

dure should be executed for your PC configuration:

1. Start the PC.

2. Open network characteristics of your operating system.

Windows

2000, XP:

Start  Settings  Network Connections  Local Area Connection (Icon) 

Properties of Internet Protocol (TCP/IP) to this link

Windows

Start  Settings  Network- and Sharing center → Change adapter settings

→ Right mouse button click on Local Area Connection (Icon) → Properties →

Double-click on Internet protocol version 4 (TCP/IPv4)

3. Select Obtain an IP address automatically for this link.

Figure 4: Selection of automatic allocation of IP-addresses