Operating instructions

BIG 10 Bridge
Version: 2013/04/15
27
LED signalling
The modem has 6 LEDs which signal the data transfer activities.
Designation
Operating status
LINK (WAN)
LAN
Remarks/
Result
LED
Power
(yellow)
Alarm
(red)
LINK
(green)
Status
(yellow)
LAN
(green)
Status
(yellow)
Start-up
Power ON
ON
The other LEDs are flashing 3 times
Initialisation
ON
flashes at
1Hz
prior to this < 15 s Alarm ON
Ready
ON
ON
min 1 SHDSL-Line sync.
SHDSL
Down (ready) /
Down (idle)
ON
flashes at
1Hz or ON
ON
OFF
Alarm LED shines if min. one SHDSL-
Line was active
G.hs transfer
ON
flashes at
1Hz or ON
flashing
at 2 s
Number of flash pulses shows first
activating Line
G.hs Line-probing
ON
flashes at
1Hz or ON
flashing
short interruption of the shining LED
Training
ON
flashes at
1Hz or ON
flashes at
1Hz
min 1 SHDSL-Line in Status Training
Data Mode
ON
flashes at
1Hz or ON
flashes at
2Hz
min 1 SHDSL-Line in Data mode
PCS sync
ON
flashes at
1Hz or ON
ON
OFF
all SHDSL-Lines of the EFM-Bonding
Group are synchronized
PCS sync
ON
flashes at
1Hz or ON
ON
ON
min. 1 SHDSL-Line of the EFM-
Bonding Group is synchronized
ETH-PORTS
disconnect
ON
OFF
OFF
LCT-Link
ON
LAN-LED flashes upon data transfer
LAN-Link
ON
LAN-LED flashes upon data transfer
Fehleranzeigen
1 Link down
(PAF4)
ON
ON
ON
all Links down
ON
ON
internal error
ON
no dedicated fault identification im-
plemented
Software update
ON
ON
ON
Initial situation
Download
ON
flashes
flashes
flashes
flashes
Flash
programming
ON
all LED ON and are switched off in clock-
wise direction
2.5 Cable connection
1. Connect the WAN-interface of the BIG 10 with the access port of your network opera-
tor, using a UTP (Unshielded Twisted Pair) CAT5 cable or better, to ensure optimal
transmission parameters. The cable contact assignment at the socket can be requested
from your network provider.
2. Link the BIG 10 with the network interface card of the PC. For this, use an Ethernet
cable and connect it to one of the „LAN“-marked RJ45-sockets on the BIG 10 and to
the RJ45-socket of the network interface card (see the related instructions).