Manualshelf

Operating instructions

ManualsBrandsElcon ManualsComputer equipmentnext BIG 10
41424344454647484950
BIG 10 Router
Version: 2011/01/19
40
LED
Colour
Status
Meaning
LINK
Status of SHDSL
green
OFF
WAN link not established
flashing
Data-transfer over minimum one SHDSL
ON
all PCS member sync; WAN link established
yellow
OFF
State WAN init done; all links down; all PCS
member sync; state without any interference
ON
fastest link PCS sync, still not all members
sync; state with any interference
flashing
(slow)
link-ID (1…4) fastest link G.hs-transfer
(up to 4 ON-pulses within 2 seconds)
flashing
(inverse)
fastest link line probing
blinking
at 1 Hz
fastest link training; „SHDSL Training“ status
blinking
at 2 Hz
fastest link data mode; „Line Probing“ status
blinking
at 4 Hz
(re-)init running; „G.hs“ status
LAN
Status of LAN
green
OFF
LAN-port not established
flashing
(inverse)
data-transfer over minimum one LAN-port
ON
Link established to at least one LAN port
yellow
OFF
state without any interference
ON
state with any interference
WLAN (only order no.
900220) Status WLAN
blue
OFF
flashing
(inverse)
ON
yellow
OFF
blinking
ON
2.5 Cable connection
1. Connect the WAN-interface of the BIG 10 with the access port of your network opera-
tor, using a UTP (Unshielded Twisted Pair) CAT5 cable or better, to ensure optimal
transmission parameters. The cable contact assignment at the socket can be requested
from your network provider.
2. Link the BIG 10 with the network interface card of the PC. For this, use an Ethernet
cable and connect it to one of the „LAN“-marked RJ45-sockets on the BIG 10 and to
the RJ45-socket of the network interface card (see the related instructions).
3. Finally use the enclosed plug-in power supply module to connect the socket „12V
DC“ of the BIG 10 to the electricity network. Do not use any other power supply
module than the one included in delivery. The use of other power supply units will re-
sult in the loss of the CE conformance and exclude any warranty claims.