Use Instructions

QUICK START GUIDE

Inserting and Replacing the Batteries

1. Turn the bottom CAP of the handle to take out the battery housing inside.

2. Insert 3 batteries (AAA) into the housing as shown in the diagram.

(Check to make sure the +/- positions are correct, when inserting batteries.)

※

The contact with the spring is the -, without the spring is the + side.

3. Insert the batteries inserted housing into the direction of the arrow, which is marked on the handle of the product,

and close the bottom CAP.

Instructions for Use

1. Switching ON/OFF : Press BUTTON 1 for 1.5 seconds.

[The light stick is in concert mode, when power is turned on for the first time]

2. Bluetooth mode ON/OFF

· Press BUTTONS 1,2 simultaneously for 1.5 seconds to connect smartphone with Bluetooth.

[The light stick lights up in blue, when it changes to Bluetooth mode.]

3. Basic Mode [Concert Mode]

· Press BUTTON 1 briefly to change the light stick color.

· Press and hold BUTTON 1 to turn off the light stick.

· Press BUTTON 2 briefly to change the flashing speed of the light stick.

[Slow > Normal > Quick]

· Press and hold BUTTON 2 to change to G-Sensor mode.

4. G-Sensor Mode

· Shake the light stick to change the color of the light stick.

· Press and hold BUTTON 1 to turn off the light stick.

· Press and hold BUTTON 2 to change to Basic mode.

* For wireless control of the light stick in the concert hall, match the ticket information, by pairing the light stick with

your smartphone.

* Since the connection between the smartphone and Bluetooth is wireless, the connection may be intermittently

disconnected during use.

*If you have trouble pairing your smartphone with the light stick, please visit the HELP DESK (Pairing Booth)

*Bluetooth only supports BLUETOOTH 4.2 or higher.

Precautions

PAGE 1
QUICK START GUIDE Inserting and Replacing the Batteries 1. Turn the bottom CAP of the handle to take out the battery housing inside. 2. Insert 3 batteries (AAA) into the housing as shown in the diagram. (Check to make sure the +/- positions are correct, when inserting batteries.) ※ The contact with the spring is the -, without the spring is the + side. 3. Insert the batteries inserted housing into the direction of the arrow, which is marked on the handle of the product, and close the bottom CAP.
PAGE 2
1. Avoid high temperature and high humidity, and keep at room temperature when storing. 2. Avoid looking directly at the LED light. 3. Please note that dropping the product or forcibly applying shock may affect LED color. 4. Be careful not to swallow the parts or put them in your mouth. 5. Be careful not to give strong impact to the product or contact with water. 6. Stop using the product if it is damaged, and do not modify or disassemble the product. 7.
PAGE 3
This device can be operated in at least one Member State without infringing applicable requirements on the use of radio spectrum. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.