Installation & Assembly

Installation Guidelines

LL-TK / LL-WAL

Life-Line Contour Shower Seats

Teak and Walnut Wood 18” and 26” Stainless Steel Folding Shower Seats

Page 1 Elcoma Metal Folding Shower Seats

Installation Guidelines

 Contour seats require in-wall backing between wall studs.

 The 18” Contour seat mounts at 16” on center, so this model can be attached directly to wall studs

that are 16” on center.

 The 26” Contour seat will require additional in-wall wood backing.

 The rear wooden slats on the Contour seats can be removed in order to clean the back wall when

necessary.

Installation Instructions

1. Pre-Installation Setup:

A. Place a drop cloth, plastic sheet, or other material down beneath the area where the seat will

be installed.

B. Remove the rear slats and place the seat on the wall in the desired location. Be sure that the

seat is level.

C. With a pencil, mark the mounting holes. Remove the seat from the wall. If drilling into tile,

mark the mounting holes with a center punch.

2. Installing the Contour Seat:

A. Drill the mounting holes with a ceramic or masonry drill bit.

PAGE 1
Installation Guidelines LL-TK / LL-WAL Life-Line Contour Shower Seats Teak and Walnut Wood 18” and 26” Stainless Steel Folding Shower Seats Installation Guidelines ČČ Contour seats require in-wall backing between wall studs. ČČ The 18” Contour seat mounts at 16” on center, so this model can be attached directly to wall studs that are 16” on center. ČČ The 26” Contour seat will require additional in-wall wood backing.
PAGE 2
B. Place the seat against the wall aligned with the holes and attach with the provided stainless steel mounting screws. C. After the seat is attached, double check that it is level. Additionally, make sure that the two mounting arms are parallel to each other and not flared in or out. Parallel mounting arms will allow the rear slats to be put back into place. (These slats can be removed later for easy cleaning of the wall). D. Replace the rear wooden slats.