Specifications Sheet

2042 E. Vernon Ave., Vernon, CA 90058 • Tel [phone] Fax [phone] • elcolighting.com
© ELCO Lighting 2019. All rights reserved • Rev. 27 Jun 2018 • ELCO Lighting reserves the right to make specification and design changes without notice.
Page 1 of 2
2042 E. Vernon Ave., Vernon, CA 90058 • Tel [phone] Fax [phone] • elcolighting.com
© ELCO Lighting 2019. All rights reserved • Rev. 27 Jun 2018 • ELCO Lighting reserves the right to make specification and design changes without notice.
Page 1 of 2
Project name:
Fixture type:
Date:
4" Double Wall New
Construction IC Housing for
GU10 Base
Features
Double wall IC construction, for use in insulated
ceilings.
Trims sold separately.
Lamp: 50W MAX 120V MR16 GU10 LED/Halogen (not
included).
Lamp Holder: MR16 GU10 socket.
Specifications
Wattage 50W
Voltage 120V
Lamp Type GU10
Damp LocationListed
Technical Details
Construction: 󰾬󰾬
• Double wall IC rated for direct contact with insulation, for use in IC or non-IC conditions.
• Housing adjusts in frame to accommodate up to 1 1/4" ceiling thickness.
• Airtight housing with gasket to restrict airflow in accordance with ASTM E-283 air-tight requirements.
• Steel housing for greater heat dissipation. Stamped galvanized steel frame.
Installation: Designed for ceiling plenums where 2x6 joists or taller joists are used. High strength hanger bars
can easilty be nailed to joists. Maximum hole cutout is 4 1/4". Suitatble for T-grid and drop ceiling applications.
See installation sheet for detailed information.
Junction Box: Positioned to accommodate straight conduit runs. Seven 1/2" trade size conduit knockouts,
four 3/4" knockouts with pry-out knockout slots. 4 Romex pryouts with strain relief.
Hanger Bars: Pre-installed hanger bars with True Nail facilitate easy installation in regular lumber,
engineered lumber, and laminated beams. Integral T-bar slots for easy installation in T-bars. Spans up to 24"
and can be repositioned 90°. Score lines allow for tool-free hanger bar size reduction. Integral leveling flange
allows for single-person installation while aligning the housings with the joists.
Electrical:
• Input Voltage: 120V AC.
• Thermally protected against improper lamping.
Trims: Compatible with ELCO 4" MR16 trims.
Dimmability:
• Dimmability based on lamp.
Lamp: Designed for use with GU10 MR16 LED lamps.
Listings:
• UL Listed for Damp Location.
• UL Listed for Wet Location with select trims.
• UL Listed for Feed Through.
• UL Listed for Direct Contact with Insulation and Combustible Material.
• Airtight per ASTM E-283.
• Install a JA8-2016-E lamp/luminaire for Title 24 Compliance.
Warranty: ELCO Lighting warrants products will be free from defects in materials and workmanship for a
period of 3 years.
Dimensions
Product Numbers
Item Lamp type Watts Voltage
EL49ICA GU10 50W 120V