Owner`s manual

iBurst Terminal Desktop Type(UTD) Manual
Setup Pane
[Setup] pane can be displayed in the main dialog window by clicking the [Setup] tab. [Setup] pane
is used to configure the display items in the [Link Info] pane.
(6)
(5)
(4)
(3)
(2)
(1)
The following describes usage of each item of the above figure.
(1) Check the [ON] radio buttons at the right hand side of the items you want to display in the
Link Info pane.
(2) Check the [OFF] radio buttons at the right hand side of the items you don’t want to display in
the Link Info pane.
(3) The configuration shown in the Display Setup subpane is activated by checking the [Apply]
button.
(4) The configuration in the Setup pane can be set to default (Default is the state in which all
radio buttons on the right hand side of display items are set to “ON”.) by clicking the [Reset]
button.
(5) By clicking the [OK] button, the current configuration will be activated and the dialog window
will be closed.
(6) By clicking the [Cancel] button, the dialog window will be closed but the current configuration
won’t be activated.
- 72 -