Specifications

Maintenance
33
Troubleshooting Guide
POSSIBLE CAUSE(S) SUGGESTED REMEDY
SYMPTOM: Oven will not reach desired temperature.
S Manifold gas pressure to too low (SG2136G).
S Gas pressure to oven is too low (SG2136G).
S Convection blower motor(s) not running.
S Fuse(s) are blown.
S Emergency stop button is pushed in (remote
control oven only).
S Defective heating element relay (SG2136E).
S Heating element(s) burned out (SG2136E ).
S Temperature hi-limit switch tripped (open) or out
of adjustment or defective.
Display: HI LIMIT TRIP --- RESET EGO
S Internal problem with control.
S *
S Contact local gas representative.
S *
S Unplug the oven power cord and check the fuses
(SG2136E). Call service if necessary.
S Pull the button out to disengage the emergency
stop.
S *
S *
S Press red EGO reset button on rear of electrical
box. Call service if necessary.
S *
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is
recommended, however, that All repairs and/or adjustments be done by your local Blodgett s ervice
agency and not by the owner/operator. Blodgett cannot assume responsibility for damage as a result
of servicing done by unqualified personnel.