Specifications

Maintenance
32
Troubleshooting Guide
POSSIBLE CAUSE(S) SUGGESTED REMEDY
SYMPTOM: Burner will not fire (SG2136G) or e lements will not heat (SG2136E).
S Control turned off.
S Temperature set point not above the ambient
temperature.
S Convecti on blower motor(s) not running.
Displ ay : BLOWER FAULT --- CALL SE R VICE
S Fuse(s) are blown.
S Emergency stop button is pushed in (remote
control oven only).
For SG2136G ovens only
S Manual gas valve closed.
S Combustio n blower motor not running.
Display: COMBUSTION BLWR FAIL --- CALL
SERVICE
S Combustio n blower pressure switch defective or
not set properly.
Displ ay : COM B PS FAULT --- CALL SERV ICE
S Burner did not ignite properly or flame ceased.
Display: IGNITION ALARM --- PRESS RESET
or NO FLAME SENSE --- RESET OR CALL SERVICE
S Press ON/OFF k ey.
S Set to the desired temperature. See page 24 of
the Operation section for instructions.
S *
S Unplug the oven power cord and check the fuses
(SG2136E). Call service if necessary.
S Pull the button out to disengage the emergency
stop.
S Open valve.
S *
S *
S Press the reset button on the electrical box
control tray, located to the left of the LED
indicator lights. Call service if necessary.
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is
recommended, however, that All repairs and/or adjustments be done by your local Blodgett s ervice
agency and not by the owner/operator. Blodgett cannot assume responsibility for damage as a result
of servicing done by unqualified personnel.