Specifications

Installation
12
Oven Assembly
CONVEYOR BELT SUPPORT
NOTE: Conveyor belt support is shipped installed
on some units.
1. Slide the drive side conveyor support rack into
theconveyorsupportguides.
NOTE: The pulley on the conveyor rack must
be inside the elect ric al box aft e r being
pushed into the oven. See View A.
2. Install the drive belt around the drive motor
pulley and the pulley on the conveyor rack.
Pull the conveyor rack forward to tighten the
belt.
3. Secure the conveyor using the spring loaded
conveyor locating pin. See View A.
4. Slide the idle side conveyor rack into the con-
veyor support guides until it touches the drive
side conveyor rack.
NOTE: If the mounting hole cannot be lined up or
the belt is too loose, the drive motor will
need to be repositioned.
Drive Side
Conveyor Rack
Idle Side
Conveyor Rack
See View A
View A
Pulley
Locating
Pin
Front and Rear
Conveyor Support
Guides
Figure 7