Service Manual

MM-E 2072-09333-00
3-27
3-6.2 Repair of Micom-Z Trunk-Mount Version
3-6.2.1 Gaining Access to Modules
1. Refer to Figure 3-17: release the 8 screws fastening the top cover, and then remove the top
cover.
Top Cover
Top Cover
Fastening Screws
(8 places)
Rear Panel
Fastening Screws
(4 places)
Front Cover
Fastening Screws
(4 places)
Body Assembly
Figure 3-17. Gaining Access to Micom-Z Trunk-Mount Version Modules
2. Release the four screws fastening the front cover to the body assembly. Keep screws and
washers for reuse.
3. Carefully separate the front cover, and then disconnect the flat cable connecting the front cover
to the LORD connector. Figure 3-18 shows the front cover after being removed.
LORD
Module
Flat Cable
to LORD
Front Cover
Figure 3-18. Micom-Z Trunk-Mount Version with Front Cover Removed