Service Manual

MM-E 2072-09333-00
3-21
3-6. MICOM-Z REPAIR PROCEDURES
3-6.1 Micom-Z Dash-Mount Version Repair
3-6.1.1 Gaining Access to Modules
1. Refer to Figure 3-11: release the 8 screws fastening the top cover, and then remove the top
cover.
Top Cover
Top Cover
Fastening Screws
(8 places)
Rear Panel
Fastening Screws
(4 places)
Front Panel
Fastening Screws
(4 places)
Body Assembly
Figure 3-11. Gaining Access to Modules
2. Release the four screws fastening the front panel to the body assembly. Keep screws and
washers for reuse.
3. Carefully separate the front panel, and then disconnect the flat cable connecting the front panel
to the LORD connector. Figure 3-12 shows the front panel after being removed.
LORD
Module
Flat Cable
to LORD
Figure 3-12. Micom-Z with Front Panel Removed